Method of drilling process control and experimental studies of resistance forces during bits drilling with PDC cutters

Описание

Тип публикации: статья из журнала

Год издания: 2020

Идентификатор DOI: 10.31897/PMI.2020.5.5

Ключевые слова: diamond drilling, drilling modes, drilling process control, drilling tool development, full factor experiment, pdc cutters

Аннотация: A rational, theoretically proved and empirically verified control system is a condition for optimal manage-ment of the drilling process in compliance with the criteria for minimizing the cost of time and material resources. A new generation of rock-cutting tools using PDC cutters (polycrystalline diamante cutters), which are extremПоказать полностьюely effective when drilling wells for various purposes in medium-hard rocks, dictates the need to develop methods and criteria for optimal control of the drilling process using this tool. The paper presents an analysis of the force interaction between rock-cutting elements, face rock, and drilling mud saturated with slam, highlights the influencing factors and provides dependencies for determining the parameters of rock failure. Empirical verification of the theoretical propositions was carried out based on the data analysis from experimental bit drilling of marble with PDC cutters with a diameter of 76.2 mm, processed using the method of full factor experiment to obtain mathematical models of factors and their graphical interpretation. The method of controlling the drilling process based on the optimal ratio of the tool rotation frequency, axial weight and deepening per one turnover is considered, which allows determining the rock failure mode at the well bottom by indirect signs and choose the optimal values of the drilling mode parameters that correspond to the most optimal conditions in terms of achieving the maximum mechanical drilling speed in conjunction with the rational mode of rock-cutting tool operation. A scheme is presented that contains possible variants of the bit run mode and ways to recognize them by the ratio of the deepening per turnover and the rotation frequency of the rock-cutting tool. © 2020, Saint-Petersburg Mining University. All rights reserved.

Ссылки на полный текст

Издание

Журнал: Journal of Mining Institute

Выпуск журнала: Vol. 245, Is. 1

Номера страниц: 539-546

ISSN журнала: 24113336

Издатель: Saint-Petersburg Mining University

Персоны

  • Neskoromnyh V.V. (Siberian Federal University, Krasnoyarsk, Russian Federation)
  • Popova M.S. (Siberian Federal University, Krasnoyarsk, Russian Federation)
  • Golovchenko A.E. (Siberian Federal University, Krasnoyarsk, Russian Federation)
  • Petenev P.G. (Siberian Federal University, Krasnoyarsk, Russian Federation)
  • Baochang L. (Jilin University, Changchun, China)