Тип публикации: статья из журнала
Год издания: 2021
Идентификатор DOI: 10.1007/s00170-021-07054-x
Ключевые слова: aluminum alloys, CASTing, combined rolling-extruding, drawing, electromagnetic mold, metal structure, physical and mechanical properties, rare earth metals, wire
Аннотация: The paper presents the results of studies of the structure and properties of a wire with a diameter of 0.5 mm from an alloy of the Al-REM system with a rare-earth metal content of 7–9%. Wire obtained as a result of the implementation of the technology of its manufacture using the methods of casting into an electromagnetic mold (EMMПоказать полностью), continuous extruding, and drawing. The rheological properties of the metal of continuously cast round billets from the experimental alloy obtained using an electromagnetic mold are determined. The modeling and analytical assessment of the possibility of carrying out the process of combined rolling-extruding (CRE) of such billets in a closed box-type roll groove of a continuous extruding unit are carried out. The features of metal shaping have been studied. The temperature-speed and technological parameters were found at which the CRE process can be carried out in a stable mode of operation. Data have been obtained for the forces acting on the die and rolls during rolling-extruding. The results of experimental studies of the process of obtaining longish deformed semi-finished products from an experimental alloy on the laboratory unit CRE-200 and the pilot plant unit CRE-400 are presented. The structure of the metal has been studied; data on the ultimate tensile strength, yield strength, relative elongation, and electrical resistance of hot-extruded rods and wires in cold-worked and annealed states have been obtained. It was found that the proposed processing modes make it possible to obtain by the method of combined rolling-extruding rods with a diameter of 9 mm in industrial conditions from longish billets with a diameter of 18 mm, cast by means of EMM. Wire in a cold-deformed and annealed state with a diameter of 0.5 obtained by drawing from the rods with a diameter of 9 mm from an experimental alloy of the Al-REM system containing 7–9% rare-earth metals with the required physical and mechanical properties.
Журнал: The International Journal of Advanced Manufacturing Technology
ISSN журнала: 02683768
Издатель: Springer-Verlag London Ltd