Тип публикации: статья из журнала
Год издания: 2015
Идентификатор DOI: 10.17580/gzh.2015.06.17
Ключевые слова: Binder, Curing kinetics, Filler, High-grade ore, Homogenization and activation, Mill tailings, Solidifying mixture, Strength
Аннотация: The authors are grateful for the contribution to K. V. Smolov, Deputy Principal Engineer for Backfilling and Support, Mining and Geology Management, O. G. Norkin, Deputy Principal Engineer for Backfilling, Komsomolsky Mine, and O. A. Gets, Category II Mine Engineer, Geotechnology Improvement Department, Center for Geodynamic SafetyПоказать полностью, Polar Division of PJSC "MMC "NORILSK NICKEL". Highlighting advantages offered by geotechnologies of high-grade ore mining with backfilling in terms of safety, minimized loss and dilution and undermined ground protection from subsidence and deformation, the authors emphasize issues connected with the conventional preparation and composition of solidifying backfills. The article describes the research into using current mill tailings of the Talnakh copper-nickel ore as a filler in preparation of solidifying backfill manufactured from mill tailings and cement (MTC) in water environment. Based on the research findings, it has been recommended to carry out pilot trial of optimal MTC mixtures ensuring the required strength of the filling mass after curing, and of a new MTC mixture manufacture technology including premixing of backfill components, homogenization and, then, activation of the mixture by hydraulic impact and cavitation in a HIC mixer. Furthermore, the authors advise on structural arrangement of a backfilling plant, including hydrotransport of total mill tailings in a slurry pipeline between processing plant and production infrastructure site, and an area of MTC manufacture using the new technology, followed with the backfill feed to underground mined-out voids.
Журнал: Gornyi Zhurnal
Выпуск журнала: Vol. 2015, Is. 6
Номера страниц: 85-88