Тип публикации: статья из журнала
Год издания: 2019
Идентификатор DOI: 10.17073/0368-0797-2019-12-918-924
Ключевые слова: Economic parameters, Grooveless rolling, Simple form profiles
Аннотация: A promising direction for production of simple profiles by rolling includes grooveless rolling. Due to the use of forming in smooth rolls, this direction significantly reduces the production cost of finished products and simplifies the rolling process. However, despite all the obvious advantages of deformation in smooth rolls, therПоказать полностьюe are disadvantages that complicate industrial implementation including the need for edging after each pass and a small coefficient of extraction in smooth rolls. It causes an increase in the number of passes. For the solution of problems encountered in current industrial implementation of grooveless rolling, it is proposed to use deprived-wide vertical stands in continuous groups. Deformation in non-water vertical stands is provided by more complete use of the reserve of contact friction forces of the drive stands installed in front of them. The conditions under which the use of non-water vertical stands is possible are determined. After solving the equation of forces equilibrium on the contact surface in the deformation center of the drive stand, dependence is obtained by which it is possible to find the value of longitudinal force provided by reserve of friction forces. By solving the equation of power balance in form of non-drive rolls, the dependence is obtained determining the longitudinal force required for deformation. The authors offer the dependence by which it is possible to determine the maximum allowed distance between the drive and non-drive stands, providing longitudinal stability of the strip. Using dependencies to determine conditions of deformation in horizontal drive and non-driven vertical mills with smooth rolls, reduction modes during rolling of rebar No. 12 in conditions of JSC “EVRAZ ZSMK” 250 continuous light section mill using roughing stands for grooveless rolling were calculated. As a result it was found that the use of non-water vertical stands allows rolling of larger cast billet of 125x125 mm square on the mill. Economic component of transition to the larger cast billet with development of grooveless rolling was estimated. Advantages of the proposed solutions are shown in comparison with classical method of rebar No. 12 rolling on 250 continuous small-grade mill of JSC “EVRAZ ZSMK”. © 2019 National University of Science and Technology MISIS. All rights reserved.
Журнал: Izvestiya Ferrous Metallurgy
Выпуск журнала: Vol. 62, Is. 12
Номера страниц: 918-924
ISSN журнала: 03680797
Издатель: National University of Science and Technology MISIS