Stabilization of calibration metrological characteristics of technological inspection tools

Описание

Год издания: 2017

Идентификатор DOI: 10.1109/ICIEAM.2016.7911599

Ключевые слова: automatization, calibration, measurement, metrological support, tolerance, variation, Calibration, Fits and tolerances, Manufacture, Measurements, Accuracy of measurements, automatization, Inspection tools, Measurement process, Metrological characteristics, Metrological supports, Random factors, variation, Inspection

Аннотация: The paper presents analysis of the results of 873 template measurements used for inspection in wagon depo. The data obtained were analyzed to confirm the stability of inspection results. It is shown that the measurement and determination of the final result by calculating the average value lead to misleading results. Random factorsПоказать полностьюaffecting measurements are also presented. The subjective factor in this process is supplied from the calibrator. To make measurement process more stable, we need to reduce the effect of these factors. One of the ways to improve measurement process and make it more stable is its automatization. Improving the accuracy of measurements is one of the main objectives concerning this issue. © 2016 IEEE.

Ссылки на полный текст

Издание

Журнал: 2016 2nd International Conference on Industrial Engineering, Applications and Manufacturing, ICIEAM 2016 - Proceedings

Авторы

  • Petrovsky Ed.A. (Department of Technological Machines and Equipment for Oil and Natural Gas Industry, Siberian Federal university, Krasnoyarsk, Russian Federation)
  • Bukhtoyarov Vladimir Viktorovich (Department of Technological Machines and Equipment for Oil and Natural Gas Industry, Siberian Federal university)
  • Savitskaya S. (Department of Technological Machines and Equipment for Oil and Natural Gas Industry, Siberian Federal university)

Вхождение в базы данных